Typical Gvrp Application - Planet Networking & Communication WGSW-50040 Configuration Manual

10.2.3 Typical GVRP Application

Scenario:
To enable dynamic VLAN information register and update among switches, GVRP protocol is to be configured
in the switch. Configure GVRP in Switch A, B and C, enable Switch B to learn VLAN100 dynamically so that
the two workstation connected to VLAN100 in Switch A and C can communicate with each other through
Switch B without static VLAN100 entries.
Configuration Item
VLAN100
Trunk port
Global GVRP
Port GVRP
Connect the two workstation to the VLAN100 ports in switch A and B, connect port 11 of Switch A to port 10 of
Switch B, and port 11 of Switch B to port 11 of Switch C.
The configuration steps are listed below:
Switch A:
Switch(config)# gvrp
Switch(config)#vlan 100
Switch(Config-Vlan100)#switchport interface ethernet 1/2-6
PC
Switch A
Switch C
PC
Figure 10-3 Typical GVRP Application Topology
Configuration description
Port 2 -6 of Switch A and C.
Port 11 of Switch A and C, Port 10, 11 of Switch B.
Switch A, B, C.
Port 11 of Switch A and C, Port 10, 11 of Switch B.
10-7
Switch B