Chapter 37 Debugging And Diagnosis For Packets Received And Sent By Cpu; Introduction To Debugging And Diagnosis For Packets Received And Sent By Cpu; Debugging And Diagnosis For Packets Received And Sent By Cpu Task List - Planet Networking & Communication WGSW-50040 Configuration Manual

Chapter 37 Debugging and Diagnosis for
37.1 Introduction to Debugging and Diagnosis for Packets
Received and Sent by CPU
The following commands are used to debug and diagnose the packets received and sent by CPU, and are
supposed to be used with the help of the technical support.
37.2 Debugging and Diagnosis for Packets Received and Sent
by CPU Task List
Global Mode
cpu-rx-ratelimit total <packets>
no cpu-rx-ratelimit total
cpu-rx-ratelimit queue-length <queue-id>
<qlen-value>
no cpu-rx-ratelimit queue-length [<queue-id>]
cpu-rx-ratelimit protocol <protocol-type>
<packets>
no cpu-rx-ratelimit protocol [<protocol-type>]
clear cpu-rx-stat protocol [<protocol-type>]
cpu-rx-ratelimit channel <channel-id>
<packets>
no cpu-rx-ratelimit channel [<channel- id>]
Admin Mode
show cpu-rx protocol [<protocol-type>]
debug driver {receive|send} [interface
{<interface-name> |all}] [protocol
{<protocol-type> |discard |all}][detail]
no debug driver {receive |send}
Packets Received and Sent by CPU
Command
Set the total rate of the CPU receiving
packets, the no
rate of the CPU receiving packets to default.
Set the length of the specified queue, the no
command set the length to default.
Set the max rate of the CPU receiving
packets of the protocol type, the no
command set the max rate to default.
Clear the statistics of the CPU received
packets of the protocol type.
This command is not supported by switch.
Show the information of the CPU received
packets of the protocol type.
Turn on the showing of the CPU receiving or
sending packet informations.
Turn off the showing of the CPU receiving or
sending packet informations.
37-1
Explanation
command sets the total