Planet Networking & Communication WGSW-50040 Configuration Manual page 179

b. Specify multiple "permit" or "deny" rules
Extended IP ACL Mode
[no] {deny | permit} icmp {{<sIpAddr> <sMask>} |
any-source | {host-source <sIpAddr>}} {{<dIpAddr>
<dMask>} | any-destination | {host-destination
<dIpAddr>}} [<icmp-type> [<icmp-code>]]
[precedence <prec>] [tos
<tos>][time-range<time-range-name>]
[no] {deny | permit} igmp {{<sIpAddr> <sMask>} |
any-source | {host-source <sIpAddr>}} {{<dIpAddr>
<dMask>} | any-destination | {host-destination
<dIpAddr>}} [<igmp-type>] [precedence <prec>] [tos
<tos>][time-range<time-range-name>]
[no] {deny | permit} tcp {{<sIpAddr> <sMask>} |
any-source | {host-source <sIpAddr>}} [s-port
{ <sPort> | range <sPortMin> <sPortMax> }]
{{<dIpAddr> <dMask>} | any-destination |
{host-destination <dIpAddr>}} [d-port { <dPort> |
range <dPortMin> <dPortMax> }]
[ack+fin+psh+rst+urg+syn] [precedence <prec>] [tos
<tos>][time-range<time-range-name>]
[no] {deny | permit} udp {{<sIpAddr> <sMask>} |
any-source | {host-source <sIpAddr>}} [s-port
{ <sPort> | range <sPortMin> <sPortMax> }]
{{<dIpAddr> <dMask>} | any-destination |
{host-destination <dIpAddr>}} [d-port { <dPort> |
range <dPortMin> <dPortMax> }] [precedence
<prec>] [tos <tos>][time-range<time-range-name>]
[no] {deny | permit} {eigrp | gre | igrp | ipinip | ip |
ospf | <protocol-num>} {{<sIpAddr> <sMask>} |
any-source | {host-source <sIpAddr>}} {{<dIpAddr>
<dMask>} | any-destination | {host-destination
Command
24-8
nomenclature; the
access-list extended
<name> " command deletes
the name-based extended IP
access-list.
Explanation
Creates an extended
name-based ICMP IP access
rule; the "no" form command
deletes this name-based
extended IP access rule.
Creates an extended
name-based IGMP IP access
rule; the "no" form command
deletes this name-based
extended IP access rule.
Creates an extended
name-based TCP IP access
rule; the "no" form command
deletes this name-based
extended IP access rule.
Creates an extended
name-based UDP IP access
rule; the "no" form command
deletes this name-based
extended IP access rule.
Creates an extended
name-based IP access rule
for other IP protocols; the "no"
form command deletes this
"no ip