Planet Networking & Communication WGSW-50040 Configuration Manual page 218

3. Configure the timeout value of querying dynamic MAC
4. Display and debug the relative information of number limitation of MAC on ports
1． Enable the number limitation function of MAC、IP on ports
Port configuration mode
switchport mac-address dynamic
maximum <value>
no switchport mac-address dynamic
maximum
2． Enable the number limitation function of MAC、IP in VLAN
VLAN configuration mode
vlan mac-address dynamic maximum
<value>
no vlan mac-address dynamic
maximum
3． Configure the timeout value of querying dynamic MAC.
Global configuration mode
mac-address query timeout <seconds>
4．Display and debug the relative information of number limitation of MAC on ports
Admin mode
show mac-address dynamic count {vlan
<vlan-id>|interface ethernet
<portName> }
debug switchport mac count
no debug switchport mac count
debug vlan mac count
no debug vlan mac count
Command
Command
Command
Command
Explanation
Enable and disable the number limitation
function of MAC on the ports.
Explanation
Enable and disable the number limitation
function of MAC in the VLAN.
Explanation
Configure the timeout value of querying
dynamic MAC.
Explanation
Display the number of dynamic MAC in
corresponding ports and VLAN.
All kinds of debug information when
limiting the number of MAC on ports.
All kinds of debug information when
limiting the number of MAC in VLAN.
26-2