Chapter 19 Dhcp Snooping Configuration; Introduction To Dhcp Snooping - Planet Networking & Communication WGSW-50040 Configuration Manual

Chapter 19 DHCP Snooping Configuration

19.1 Introduction to DHCP Snooping

DHCP Snooping means that the switch monitors the IP-getting process of DHCP CLIENT via DHCP protocol.
It prevents DHCP attacks and illegal DHCP SERVER by setting trust ports and untrust ports. And the DHCP
messages from trust ports can be forwarded without being verified. In typical settings, trust ports are used to
connect DHCP SERVER or DHCP RELAY Proxy, and untrust ports are used to connect DHCP CLINET. The
switch will forward the DCHP request messages from untrust ports, but not DHCP reply ones. If any DHCP
reply messages is received from a untrust port, besides giving an alarm, the switch will also implement
designated actions on the port according to settings, such as "shutdown", or distributing a "blackhole". If
DHCP Snooping binding is enabled, the switch will save binding information (including its MAC address, IP
address, IP lease, VLAN number and port number) of each DHCP CLINET on untrust ports in DHCP snooping
binding table With such information, DHCP Snooping can combine modules like dot1x and ARP, or implement
user-access-control independently.
Defense against Fake DHCP Server: once the switch intercepts the DHCP Server reply packets（including
DHCPOFFER, DHCPACK, and DHCPNAK）, it will alarm and respond according to the situation（shutdown
the port or send Black hole） 。
Defense against DHCP over load attacks: To avoid too many DHCP messages attacking CPU, users
should limit the DHCP speed of receiving packets on trusted and non-trusted ports.
Record the binding data of DHCP: DHCP SNOOPING will record the binding data allocated by DHCP
SERVER while forwarding DHCP messages, it can also upload the binding data to the specified server to
backup it. The binding data is mainly used to configure the dynamic users of dot1x user based ports. Please
refer to the chapter called"dot1x configuration" to find more about the usage of dot1x use-based mode.
Add binding ARP: DHCP SNOOPING can add static binding ARP according to the binding data after
capturing binding data, thus to avoid ARP cheating.
Add trusted users: DHCP SNOOPING can add trusted user list entries according to the parameters in
binding data after capturing binding data; thus these users can access all resources without DOT1X
authentication.
Automatic Recovery: A while after the switch shut down the port or send blockhole, it should automatically
recover the communication of the port or source MAC and send information to Log Server via syslog.
LOG Function: When the switch discovers abnormal received packets or automatically recovers, it should
send syslog information to Log Server.
The Encryption of Private Messages: The communication between the switch and the inner network
security management system TrustView uses private messages. And the users can encrypt those messages
of version 2.
Add option82 Function: It is used with dot1x dhcpoption82 authentication mode. Different option 82 will be
19-1