Planet Networking & Communication WGSW-50040 Configuration Manual page 16

Layer2 Function
Port Configuration
Port Status
VLAN
Bandwidth Control
Link Aggregation
QoS
IGMP Snooping
Multicast
Access Control List
Security
The right configuration for users to adopt radius server's shell management
Supports CLI, Console (RS-232), Telnet
Supports SNMPv1 / v2c / v3
Supports Security IP safety net management function ： avoid unlawful
landing at nonrestrictive area
Support Syslog server for IPv4 and IPv6
Supports TACACS+
Port disable/enable.
Auto-negotiation 10/100/1000Mbps full and half duplex mode selection.
Flow Control disable/enable.
Bandwidth control on each port
Port Loopback detect
Display each port's speed duplex mode, link status, Flow control status.
Auto negotiation status.
802.1Q Tagged Based VLAN, up to 4K VLAN groups
Q-in-Q
GVRP for VLAN Management
Private VLAN Edge (PVE) supported
TX / RX / Both
IEEE 802.3ad LACP / Static Trunk
Supports 8 groups of 8-Port trunk
8 priority queues on all switch ports
Supports for strict priority and weighted round robin (WRR) CoS policies
Traffic classification:
- IEEE 802.1p CoS / ToS
- IPv4 / IPv6 DSCP
- Port-Based QoS
Strict priority and Weighted Round Robin (WRR) CoS policies
IGMP (v1 / v2) Snooping, IGMP Querier mode
IGMP v1/ v2 / v3 Snooping
IGMP Querier mode support
MLDv1 / v2, MLD v1/v2 Snooping
Support Standard and Expanded ACL
IP-Based ACL / MAC-Based ACL
Time-Based ACL
Up to 512 entries
Support MAC + port binding
IPv4 / IPv6 + MAC + port binding
1-3