Fuzzy Match Support - Planet Networking & Communication WGSW-50040 Configuration Manual

Returned Information: error
Output error message
Unrecognized command or illegal
parameter!
Ambiguous command
Invalid command or parameter
This command is not exist in
current mode
Please configure precursor
command "*" at first!
syntax error : missing '"' before the
end of command line!

3.2.6 Fuzzy Match Support

Switch shell support fuzzy match in searching command and keyword. Shell will recognize commands or
keywords correctly if the entered string causes no conflict.
For example:
1) For command "show interfaces status ethernet1/1", typing "sh in status ethernet1/1" will work.
2) However, for command "show running-config", the system will report a "> Ambiguous command!"
error if only "show r" is entered, as Shell is unable to tell whether it is "show run" or "show
running-config". Therefore, Shell will only recognize the command if "sh ru" is entered.
Explanation
The entered command does not exist, or there is
error in parameter scope, type or format.
At least two interpretations is possible basing on
the current input.
The command is recognized, but no valid
parameter record is found.
The command is recognized, but this command
can not be used under current mode.
The command is recognized, but the prerequisite
command has not been configured.
Quotation marks are not used in pairs.
3-21