Chapter 4 Basic Switch Configuration; Basic Configuration - Planet Networking & Communication WGSW-50040 Configuration Manual

Chapter 4 Basic Switch Configuration

4.1 Basic Configuration

Basic switch configuration includes commands for entering and exiting the admin mode, commands for
entering and exiting interface mode, for configuring and displaying the switch clock, for displaying the version
information of the switch system, etc.
Command
Normal User Mode/ Admin Mode
enable
disable
Admin Mode
config [terminal]
Various Modes
exit
Except User Mode/ Admin Mode
end
Admin Mode
clock set <HH:MM:SS>
[YYYY.MM.DD]
show version
set default
write
reload
Explanation
The User uses enable command to step into admin
mode from normal user mode. The disable command
is for exiting admin mode.
Enter global mode from admin mode.
Exit current mode and enter previous mode, such as
using this command in global mode to go back to
admin mode, and back to normal user mode from
admin mode.
Quit current mode and return to Admin mode when not
at User Mode/ Admin Mode.
Set system date and time.
Display version information of the switch.
Restore to the factory default.
Save current configuration parameters to Flash
Memory.
Hot reset the switch.
4-1