Examples Of Ipv6 Radius Application - Planet Networking & Communication WGSW-50040 Configuration Manual

25.3.3 Examples of IPv6 Radius Application

2004:1:2:3::2
2004:1:2:3::1 Radius Server
2004:1:2:3::3
25-17 IPv6 Radius
Figure
Connect the computer to the interface 1/2 of the switch, and enable IEEE802.1x on interface1/2. Use MAC
based authentication. Configure the IP address of the switch as 2004:1:2:3::2, and connect the switch with
any interface except interface 1/2 to the RADIUS authentication server. Configure the IP address of the
RADIUS server to be 2004:1:2:3::3. Use the default ports 1812 and 1813 for authentication and accounting
respectively. Install the IEEE802.1x authentication client software on the computer, and use the client for
IEEE802.1x authentication.
The detailed configurations are listed as below:
Switch(config)#interface vlan 1
Switch(Config-if-vlan1)#ipv6 address 2004:1:2:3::2/64
Switch(Config-if-vlan1)#exit
Switch(config)#radius-server authentication host 2004:1:2:3::3
Switch(config)#radius-server accounting host 2004:1:2:3::3
Switch(config)#radius-server key test
Switch(config)#aaa enable
Switch(config)#aaa-accounting enable
Switch(config)#dot1x enable
Switch(config)#interface ethernet 1/2
Switch(Config-If-Ethernet1/2)#dot1x enable
Switch(Config-If-Ethernet1/2)#dot1x port-control auto
Switch(Config-If-Ethernet1/2)#exit
25-20