Operation - ABB ACS310 User Manual

70 Control panels

Operation

You operate the control panel with the help of menus and keys. You select an option,
eg operation mode or parameter, by scrolling the
option is visible in the display and then pressing the
With the key, you return to the previous operation level without saving the made
changes.
The Basic Control Panel has five panel modes: Output, Reference, Parameter, Copy
and Fault. The operation in the first four modes is described in this chapter. When a
fault or alarm occurs, the panel goes automatically to the Fault mode showing the
fault or alarm code. You can reset the fault or alarm in the Output or Fault mode (see
chapter
Fault tracing
After the power is switched on, the panel is in the
Output mode, where you can start, stop, change the
direction, switch between local and remote control and
monitor up to three actual values (one at a time). To do
other tasks, go first to the Main menu and select the
appropriate mode.
How to do common tasks
The table below lists common tasks, the mode in which you can perform them and the page
number where the steps to do the task are described in detail.
Task
How to switch between local and remote control
How to start and stop the drive
How to change the direction of the motor rotation
How to browse the monitored signals
How to set the frequency reference
How to change the value of a parameter
How to select the monitored signals
How to reset faults and alarms
How to copy parameters from the drive to the control panel
How to restore parameters from the control panel to the drive
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
on page 287).
and arrow keys until the
key.
491
REM
OUTPUT
PAr
REM
MENU
Mode
Any
Any
Any
Output
Reference
Parameter
Parameter
Output, Fault
Copy
Copy
.
Hz
FWD
FWD
Page
71
71
71
72
73
74
75
287
77
77