How To Perform A Manual Start-Up - ABB ACS310 User Manual

How to perform a manual start-up

For the manual start-up, you can use the Basic Control Panel or the Assistant Control
Panel. The instructions below are valid for both control panels, but the displays
shown are the Basic Control Panel displays, unless the instruction applies to the
Assistant Control Panel only.
Before you start, ensure that you have the motor nameplate data on hand.
Apply input power.
The Basic Control Panel powers up into the
Output mode.
The Assistant Control Panel asks if you want to
run the Start-up Assistant. If you press
Start-up Assistant is not run, and you can
continue with manual start-up in a similar manner
as described below for the Basic Control Panel.
MANUAL ENTRY OF START-UP DATA (parameter group 99)
If you have an Assistant Control Panel, select the
language (the Basic Control Panel does not
support languages). See parameter
values of the available language alternatives.
For instructions on how to set parameters with the
Assistant Control Panel, see section
on page 78.
Panel
Enter the motor data from the motor nameplate:
ABB Motors
3
motor M2AA 200 MLA 4
IEC 200 M/L 55
Hz kW
V
690 Y 30
50
400 D 50
30
660 Y 50
30
380 D 30
50
50
415 D 30
440 D
60
Cat. no
3GAA 202 001 - ADA
6312/C3
• motor nominal voltage (parameter
Setting of parameter
example of parameter setting with the Basic Control
Panel. You find more detailed instructions in section
Basic Control Panel
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
POWER-UP
Assistant Control
No
Ins.cl. F
r/min A
cos
1475 32.5 0.83
56
1475 0.83
1470 34 0.83
1470 59 0.83
1475 54 0.83
35 1770 59 0.83
6210/C3
IEC 34-1
is shown below as an
9905
on page 68.
Start-up and control with I/O 59
REM
OUTPUT
REM
, the Do you want to
EXIT
use the start-up
assistant?
REM
9901 LANGUAGE
for the
9901
[0]
CANCEL
Note: Set the motor data to
exactly the same value as on
the motor nameplate. For
example, if the motor nominal
speed is 1440 rpm on the
nameplate, setting the value of
parameter
SPEED to 1500 rpm results in
IP 55
the wrong operation of the
IA/IN t E/s
drive.
380 V
supply
voltage
180
)
9905
REM
00
.
FWD
CHOICE
Yes
No
00:00
EXIT OK
PAR EDIT
ENGLISH
00:00
SAVE
MOTOR NOM
9908
9905
PAR FWD
Hz