Application Macros; What This Chapter Contains; Overview Of Macros - ABB ACS310 User Manual

Application macros

What this chapter contains

The chapter describes the application macros. For each macro, there is a wiring
diagram showing the default control connections (digital and analog I/O). The chapter
also explains how to save a user macro and how to recall it.

Overview of macros

Application macros are preprogrammed parameter sets. While starting up the drive,
the user typically selects one of the macros - the one that is best suited for the
purpose - with parameter
saves the result as a user macro.
The ACS310 has eight standard macros and two user macros. The table below
contains a summary of the macros and describes suitable applications.
Macro
ABB Standard
3-wire
Alternate
Motor
Potentiometer
Hand/Auto
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
APPLIC MACRO, makes the essential changes and
9902
Suitable applications
Ordinary speed control applications where no, one, two or three constant
speeds are used. Start/stop is controlled with one digital input (level start
and stop). It is possible to switch between two acceleration and
deceleration times.
Ordinary speed control applications where no, one, two or three constant
speeds are used. The drive is started and stopped with push buttons.
Speed control applications where no, one, two or three constant speeds
are used. Start, stop and direction are controlled by two digital inputs
(combination of the input states determines the operation).
Speed control applications where no or one constant speed is used. The
speed is controlled by two digital inputs (increase / decrease / keep
unchanged).
Speed control applications where switching between two control devices is
needed. Some control signal terminals are reserved to one device, the
rest for the other. One digital input selects between the terminals (devices)
in use.
Application macros 99
10