Panel Comm - ABB ACS310 User Manual

236 Actual signals and parameters
All parameters
No. Name/Value
46 PUMP CLEANING Set-up of pump cleaning.
4601 PUMP CLEAN
TRIG
NOT SEL
DI1
DI2
DI3
DI4
DI5
DI1/SUP1OVR Enable on the rising edge of digital input DI1, trigger on
DI2/SUP1OVR See selection DI1/SUP1OVR.
DI3/SUP1OVR See selection DI1/SUP1OVR.
DI4/SUP1OVR See selection DI1/SUP1OVR.
DI5/SUP1OVR See selection DI1/SUP1OVR.
SUPRV1
OVER
DRIVE START Trigger when the drive receives a start command
TIMER TRIG
DI1(INV)
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Description
Defines how Pump cleaning is triggered. The pump
cleaning sequence consists of forward and reverse "steps".
Forward
4602
Reverse
4607 4605 4604
WARNING! Before enabling the Pump cleaning
function ensure it is safe to perform the Pump cleaning
sequence with the connected equipment.
Notes:
The Pump cleaning overrides parameter
The Pump cleaning function observes the maximum forward
and reverse frequencies (parameters
FREQ and MAXIMUM FREQ).
2008
The Pump cleaning always uses acceleration time 2
(parameter 2205) and deceleration time 2 (parameter
2206).
The drive must be started and its Run Enable signal must
be present before the Pump cleaning sequence can start.
No triggering source defined.
Trigger on the rising edge of digital input DI1
See selection DI1.
See selection DI1.
See selection DI1.
See selection DI1.
SUPRV1 OVER (parameter
parameter group
32 SUPERVISION.
Trigger on SUPRV1 OVER (parameter
OUTPUT 1). See parameter group
Pump cleaning sequence is started periodically at intervals
defined by parameter
Trigger on the falling edge of digital input DI1
4603
4606 4604 4605 4604
4608
1003
2007
RELAY OUTPUT 1). See
1401
1401
32 SUPERVISION.
TRIG TIME.
4607
Def/FbEq
NOT SEL
t
DIRECTION.
MINIMUM
0
1
2
3
4
5
7
8
9
10
11
RELAY 12
13
14
-1