Motor Temp Meas - ABB ACS310 User Manual

All parameters
No. Name/Value
3415 SIGNAL3
PARAM
0, 101...178
3416 SIGNAL3 MIN
x...x
3417 SIGNAL3 MAX Defines the maximum value for the signal selected by
x...x
3418 OUTPUT3 DSP
FORM
3419 OUTPUT3
UNIT
3420 OUTPUT3 MIN Sets the minimum display value for the signal selected by
x...x
3421 OUTPUT3
MAX
x...x
35 MOTOR TEMP
MEAS
3501 SENSOR
TYPE
NONE
1 x PT100
2 x PT100
3 x PT100
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Description
Selects the third signal to be displayed on the control panel
in display mode. See par
Parameter index in group
SPEED. If value is set to 0, no signal is selected.
0102
Defines the minimum value for the signal selected by
parameter 3415. See parameter
Setting range depends on parameter
PARAM setting.
parameter SIGNAL3 PARAM. See parameter
3415
SIGNAL1 MIN.
Setting range depends on parameter
PARAM setting.
Defines the format for the displayed signal selected by
parameter SIGNAL3 PARAM.
3415
See parameter
3404
Selects the unit for the for the displayed signal selected by
parameter SIGNAL3 PARAM.
3415
See parameter
3405
parameter SIGNAL3 PARAM. See parameter
3415
SIGNAL1 MIN.
Setting range depends on parameter
PARAM setting.
Sets the maximum display value for the signal selected by
parameter SIGNAL3
3415
SIGNAL1 MIN.
Setting range depends on parameter
Motor temperature measurement. See section
temperature measurement through the standard I/O
page 139.
Activates the motor temperature measurement function and
selects the sensor type. See also parameter group
ANALOG OUTPUTS.
The function is inactive.
The function is active. The temperature is measured with
one Pt 100 sensor. Analog output AO feeds constant current
through the sensor. The sensor resistance increases as the
motor temperature rises, as does the voltage over the
sensor. The temperature measurement function reads the
voltage through analog input AI1/2 and converts it to
degrees centigrade.
The function is active. Temperature is measured using two
Pt 100 sensors. See selection 1 x PT100.
The function is active. T emperature is measured using three
Pt 100 sensors. See selection 1 x PT100.
Actual signals and parameters 207
SIGNAL1 PARAM.
3401
01 OPERATING
SIGNAL1 MIN.
3402
3415
3415
OUTPUT1 DSP FORM.
OUTPUT1 UNIT.
3415
PARAM. See parameter
3415
Def/FbEq
105
DATA. Eg 102 = 1 = 1
-
SIGNAL 3 -
-
3402
SIGNAL3 -
DIRECT
-
-
-
-
3402
SIGNAL3 -
-
3402
setting. -
Motor
on
NONE
15
0
1
2
3