Installing The Battery - Lenovo BladeCenter HX5 7873 Problem Determination And Service Manual

Blade server
Table of Contents

Advertisement

Step 11. Use your thumb and index finger to lift the battery from the socket.
Step 12. Dispose of the battery as required by local ordinances or regulations.

Installing the battery

Use this information to install a battery on the system board in the blade server.
The following notes describe information that you must consider when you are replacing the battery in the
blade server:
• You must replace the battery with a lithium battery of the same type from the same manufacturer.
• To order replacement batteries, call 1-800-426-7378 within the United States, and 1-800-465-7999 or 1-
800-465-6666 within Canada. Outside the U.S. and Canada, call your IBM marketing representative or
authorized reseller.
• After you replace the battery, you must reconfigure the blade server and reset the system date and time.
• To avoid possible danger, read and follow the following safety statement.
Statement 2
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an equivalent type battery
recommended by the manufacturer. If your system has a module containing a lithium battery, replace
it only with the same module type made by the same manufacturer. The battery contains lithium and
can explode if not properly used, handled, or disposed of. Do not:
• Throw or immerse into water
• Heat to more than 100° C (212° F)
• Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
To install the battery, complete the following steps:
Attention: Touching the battery on a metal surface, such as the side of the blade server, when you replace
the battery can cause it to fail.
Step 1.
Before you begin, read "Safety" on page v and "Installation guidelines" on page 65.
Step 2.
If the blade server or scalable blade complex is installed in a BladeCenter chassis, remove it. See
"Removing the blade server from the BladeCenter chassis" on page 66 for instructions.
Step 3.
Carefully lay the blade server on a flat, static-protective surface.
.
Chapter 4
Removing and replacing blade server components
77

Advertisement

Table of Contents
loading

Table of Contents