Table of Contents
Advertisement
1. Using a screwdriver or a coin, turn each of the screws toward the middle of the blade server
until they are in the unlocked position.
2. While you lift the back of the access panel, slide the panel away from the bezel.
• Complete the following steps to remove the embedded hypervisor card access panel on a
BladeCenter HX5 blade server that does have tall heat sinks:
1. Using a screwdriver, remove each of the screws on the right access panel.
2. Lift the access panel away from the blade server.
Step 9.
Locate the hypervisor interposer on the system board (see "Parts listing - BladeCenter HX5" on
page 57).
Step 10. Press down on the front edge of the hypervisor interposer to disengage the hypervisor interposer
from the hypervisor interposer card guide.
114
BladeCenter HX5 Blade ServerProblem Determination and Service Guide
Advertisement
Table of Contents
