Table of Contents
Advertisement
Step 10. Lift the scalability tray away from the blade server.
Step 11. If you are instructed to return the scalability tray, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
Installing the scalability tray
Use this information to install the scalability tray on a blade server.
To install the scalability tray, complete the following steps:
Step 1.
Before you begin, read "Safety" on page v and "Installation guidelines" on page 65.
Step 2.
If the blade server is installed in a BladeCenter chassis, remove it (see "Removing the blade server
from the BladeCenter chassis" on page 66 for instructions).
Step 3.
Carefully lay the blade server on a flat, static-protective surface, with the cover side down.
Step 4.
Align the scalability tray flush with the blade server in the start position. The pins on the scalability
tray should be aligned with the holes in the blade server.
Step 5.
Pressing down firmly on the middle of the tray, slide the scalability tray forward toward the bezel
until there is an audible click from each side of the blade server.
80
BladeCenter HX5 Blade ServerProblem Determination and Service Guide
Advertisement
Table of Contents
