Lenovo BladeCenter HX5 7873 Problem Determination And Service Manual page 190

• Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
• See "Parts listing - BladeCenter HX5" on page 57 to determine which components are CRUs and which
components are FRUs.
• If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
Type Error Message
Error System board, temperature (Inlet
Temp) non-recoverable
Error Proc/IO module 1, temperature (IOH
Temp) non-recoverable
Error Code: 0x80070600
Note: Multiple events can be displayed for this error code. Be sure to read the message text to determine the
appropriate recovery actions.
174
BladeCenter HX5 Blade ServerProblem Determination and Service Guide
Action
1. Make sure that the room temperature is within the
operating specifications (see "Features and
specifications" on page 4).
2. Make sure that none of the air vents on the BladeCenter
chassis and on the blade server are blocked.
3. Make sure that all of the fans on the BladeCenter chassis
are running.
4. Make sure that each bay of the BladeCenter chassis
contains either a device or a filler.
5. Make sure that the blade server is not missing any heat
sinks, DIMMs, or heat-sink fillers (see "Parts listing -
BladeCenter HX5" on page 57).
6. (Trained service technician only) Make sure that the
microprocessor heat sink is properly attached to the
microprocessor (see "Installing a microprocessor and heat
sink" on page 134).
1. Make sure that the room temperature is within the
operating specifications (see "Features and
specifications" on page 4).
2. Make sure that none of the air vents on the BladeCenter
chassis and on the blade server are blocked.
3. Make sure that all of the fans on the BladeCenter chassis
are running.
4. Make sure that each bay of the BladeCenter chassis
contains either a device or a filler.
5. Make sure that the blade server is not missing any heat
sinks, DIMMs, or heat-sink fillers (see "Parts listing -
BladeCenter HX5" on page 57).
6. (Trained service technician only) Make sure that the
microprocessor heat sink is properly attached to the
microprocessor (see "Installing a microprocessor and heat
sink" on page 134).