Table of Contents
Advertisement
Step 6.
If you are installing an IBM MAX5 for the first time, locate the power sharing connector on the
BladeCenter HX5 blade server and remove the power jumper if one is installed (see "Blade server
connectors - BladeCenter HX5" on page 12).
Step 7.
If you are installing the IBM MAX5 expansion blade option for the first time on an BladeCenter HX5
with tall heat sinks, complete the following steps:
1. Remove the operator control panel access panel:
a. Using a screwdriver, remove each of the screws on the right access panel.
b. Lift the access panel away from the blade server.
2. Remove the embedded hypervisor card access panel:
a. Using a screwdriver, remove each of the screws on the right access panel.
b. Lift the access panel away from the blade server.
3. Install the EMC gasket on the upper ridge of the BladeCenter HX5 blade server bezel.
4. Install the operator control panel access panel:
90
BladeCenter HX5 Blade ServerProblem Determination and Service Guide
Advertisement
Table of Contents
