Table of Contents
Advertisement
1. Using a screwdriver or a coin, turn each of the screws toward the middle of the blade server
until they are in the unlocked position.
2. While you lift the back of the access panel, slide the panel away from the bezel.
• Complete the following steps to remove the operator control panel access panel on a
BladeCenter HX5 blade server that does have tall heat sinks:
1. Using a screwdriver, remove each of the screws on the right access panel.
2. Lift the access panel away from the blade server.
Step 9.
Locate the control-panel connector on the blade server (see "Blade server connectors -
BladeCenter HX5" on page 12).
Step 10. Touch the static-protective package that contains the control panel to any unpainted metal surface
on the BladeCenter unit or any unpainted metal surface on any other grounded rack component in
128
BladeCenter HX5 Blade ServerProblem Determination and Service Guide
Advertisement
Table of Contents
