Disconnect Cables From The Server; Accessing Server Components - Oracle SPARC S7-2 Service Manual

Disconnect Cables From the Server

Disconnect Cables From the Server
Caution -
connected even when the system is powered off.
1. Label all cables connected to the server.
2. Power down the server.
See "Power Off the Server" on page
3. Disconnect the power cords from the rear of the server.
4. Disconnect all data cables from the rear of the server.
Gain access to the internal server components.
5.
See "Accessing Server Components" on page
Related Information
"Rear Panel Components" on page 13
■
"Extend the Server to the Service Position" on page 41
■
"Reconnect Data Cables and Power Cords" on page 149
■

Accessing Server Components

These topics explain how to access components on the outside and the inside of the server.
Perform these tasks in this order, as needed.
"Prevent ESD Damage" on page 41
■
"Extend the Server to the Service Position" on page 41
■
"Remove the Cable Management Arm" on page 42
■
"Remove the Server From the Rack" on page 47
■
"Open the Server Fan Door" on page 48
■
"Remove the Top Cover" on page 49
■
Related Information
"Safety Information" on page 33
■
40 SPARC S7-2 Server Service Manual • March 2017
The system supplies standby power to the circuit boards when the power cords are
38.
40.