Servicing The Eusb Drive; Remove The Eusb Drive - Oracle SPARC S7-2 Service Manual

Servicing the eUSB Drive

These procedures require that you handle components that are sensitive to static
Caution -
discharge. This sensitivity can cause the component to fail. To avoid damage, ensure that you
follow antistatic practices to
Ensure that all power is removed from the server before removing or installing an
Caution -
eUSB drive or damage to the drive might occur. You must disconnect all power cables from the
system before performing these procedures.
These topics describe how to service the eUSB drive.
"Remove the eUSB Drive" on page 115
■
"Install the eUSB Drive" on page 116
■
Related Information
"Detecting and Managing Faults" on page 21
■
"Preparing for Service" on page 33
■

Remove the eUSB Drive

This is a cold-service procedure that can be performed by a customer. Power down the server
completely before performing this procedure.
Prepare for servicing.
1.
See "Preparing for Service" on page
2. Loosen the screw that attaches the eUSB drive to the motherboard.
Save the screw to use with the new eUSB drive.
"Prevent ESD Damage" on page
33.
41.
Servicing the eUSB Drive 115