Lens Replacement; Remove Lens - Christie CP2000-M Setup Manual

Section 4: Maintenance
4.3

LENS REPLACEMENT

4.3.1 REMOVE LENS

1. Power down the projector. Allow the fans to cool the lamp before unplugging the projector. If
necessary, a lens can be swapped out while the projector is running, but this can result in dust
being drawn into the projector. Avoid if possible.
2. Install the lens cap (Figure 4-4, 1) and release the lens clamp by pushing it up (Figure 4-4, 2).
3. If necessary, remove the 2 capscrews securing the lens to the lens mount (Figure 4-4, 3).
4. Pull the lens out of the lens mount. The lens, motorized zoom and focus connectors disconnect
when the lens is pulled straight from the mount.
4-4
F 4-3 L A
IGURE ENS SSEMBLY
F 4-4 R L
IGURE ELEASE ENS
C
LAMP
CP2000-M/MR Setup Guide
020-100205-03 Rev. 1 (05/09)