Table of Contents
Advertisement
optional SFPs to provide a second quad-link 4K/UltraHD output. This output can
be used to feed an AJA Hi5-4K-Plus with an HDMI 2.0a output to connect directly
to a 4K HDMI 2.0 monitor. The Hi5-4K-Plus can be configured to transmit a HDMI
HDR Infoframe with static metadata to a HDR capable display.
Another example is equipping the FS-HDR with optional SFPs to provide four
channel monitoring when in Four Channel mode. By using the SFPs to provide an
additional four outputs, each channel will have a second SDI output that can be
fed to an AJA Hi5-Plus for HDMI 1.4 monitoring.
GPI Connections
The FS-HDR has four GPI inputs and four GPI outputs. The GPI inputs and outputs
are electrically isolated from the power and ground on the FS-HDR frame.
Electrical isolation is provided for up to four pieces of external equipment.
See
"GPI Pinouts" on page 128
to work with external devices that you want to use to control the FS-HDR or that
you want the FS-HDR to control.
Stand Alone Tests
The stand alone tests can be performed without a computer, using the FS-HDR
front panel controls and rear connections. The following procedures assume
the FS-HDR is at factory defaults (taken from a newly opened box). If not set to
defaults, the FS-HDR may behave differently.
NOTE: FS-HDR units are configured at the factory to operate in Four Channel Mode.
First Power Up
The following workflow powers up a default FS-HDR and demonstrates some
example alarms.
Setup
• Ensure the FS-HDR is completely disconnected (all video, audio, network, and
power connector ports are empty).
Procedure
1. Connect both FS-HDR power cords to mains AC and allow time for the unit
to boot up. Observe the front panel LEDs.
• The REF LED will light red, indicating an alarm condition. By default the
2. Press the front panel STATUS button, then turn the SELECT knob to view
various Status menus.
• The Status menu for Video Processor 1 will report No Input for IN1, the
Video Format Status screen
IN1
BKGD
GEN
OUT1
FS-HDR Frame Synchronizer/Converter/HDR-WCG Processor v1.0r1
for information on how to wire the GPI connector
FS-HDR is configured to operate genlocked to an external reference signal.
port is disconnected), and the GEN (Genlock) parameter will report Ref
(configured for external reference) but will also report No Input.
SDI 1
Black
Ref
Video Format Alarm Status screen
No Input
IN1
SDI 1
1080i59
BKGD
Black
No Input
GEN
Ref
1080i59
Rate
40
OK
OK
No Ref
59/29/23
www.aja.com
Advertisement
Table of Contents
