Table of Contents
Advertisement
Front Panel SNMP Configuration
FS-HDR SNMP configuration can be accomplished using the front panel or with
the web browser computer interface (if Remote Control is enabled).
The FS-HDR front panel screens for SNMP are accessible through the CONFIG
button. The direct SNMP configuration screens are:
• 4.0 SNMP Enable
• 4.1 SNMP Trap Destination 1
• 4.2 SNMP Trap Port 1
• 4.3 SNMP Trap Destination 2
• 4.4 SNMP Trap Port 2
These SNMP direct configuration parameters are described later in this chapter.
Front Panel Octet Value Entry Procedure
Set the octets (numbers between periods) values as follows:
1. Push ADJUST momentarily to enter edit mode.
2. Turn SELECT to select the octet you want to edit, indicated by blinking.
3. Turn ADJUST to enter the new value.
• If you need to revert to the previous setting (undo changes), push SELECT.
4. Push ADJUST momentarily to save and activate the new setting.
• If you want to revert to the default value, hold down ADJUST for 4 seconds.
Web Browser SNMP Configuration
SNMP direct configuration settings are available on the Config screen of the web
browser interface.
Figure 39. Web Browser Config Screen SNMP Parameters
FS-HDR Frame Synchronizer/Converter/HDR-WCG Processor v1.0r1
121
www.aja.com
Advertisement
Table of Contents
