Table of Contents
Advertisement
3.3 Subnet Mask
This parameter determines the subnet mask used by the FS-HDR for TCP/IP
networking. Consult your network administrator about how to set this value.
Subnet Mask variable
3.4 Default Gateway
This parameter determines the gateway or router used on your LAN for TCP/IP
networking. Consult your network administrator about how to set this value.
Without a properly configured default gateway (whether you have a router/
gateway or not), the FS-HDR will be unable to see other FS units on the network,
although you may still be able to control this unit via a web browser. Also, without
a proper gateway defined, the discovery feature on the Network web page will
fail to list other FS units on the network.
Gateway Address variable
3.5 MAC Address (view only)
Selecting this parameter allows you to view the MAC address. The MAC address
is a unique value associated with the FS-HDR's internal network adapter. MAC
addresses are also known as hardware addresses or physical addresses. MAC
addresses uniquely identify an Ethernet adapter on a LAN.
MAC address format: MM:MM:MM:SS:SS:SS
The value is 12-digit hexadecimal, where the first half identifies the manufacturer
and the second half identifies the unique serial number.
4 SNMP Enable Parameters
The following parameters are used to setup the FS-HDR SNMP (Simple Network
Management Protocol) feature.
• 4.0 SNMP Enable
• 4.1 SNMP Trap Destination 1
• 4.2 SNMP Trap Port 1
• 4.3 SNMP Trap Destination 2
• 4.4 SNMP Trap Port 2
Refer to
FS-HDR supports it.
About FS-HDR Alarms
The following FS-HDR alarm parameters affect how the front panel LEDs and Web
UI report error conditions. When suppressed, front panel LEDs will not light red,
and the Web UI will not report that particular error status. Suppressed alarms do
not affect the information reported on the FS-HDR front panel Status menus, and
does not affect SNMP messaging.
FS-HDR Frame Synchronizer/Converter/HDR-WCG Processor v1.0r1
Enter a subnet mask compatible with your LAN. This is only needed for
Static IP configurations.
If IP Config is set to DHCP, the Subnet Mask is set by the DHCP server
and cannot be changed by the user.
If IP Config is set to Default Addr, the default Subnet Mask is
255.255.255.0
Enter the address of the gateway or router used to connect the
FS-HDR to the network. Default: 192.168.0.1
"Chapter 6 SNMP" on page 120
for a description of SNMP and how the
64
www.aja.com
Advertisement
Table of Contents
