Table of Contents
Advertisement
P/S 1 and P/S 2
Two IEC-60320 3-pin grounded connectors provide AC power to the two
independent power supplies. The supplies are autosensing for 100–240 VAC,
50/60 Hz. Only one connection is required for operation, but both connectors
must be plugged into AC power for redundant power protection.
AES/EBU Digital Audio
Two GPI DB-25F connectors provide input and output of 16 channels of balanced
digital audio. See
"Audio Connection Pinouts" on page
129.
MADI BNC
64 channel MADI output and input, on separate BNC connectors.
MADI Fiber
64 channel MADI output and input, on separate Multi-Mode fiber ST connectors.
GPI
The GPI DB-25F connector provides connection to external equipment or circuits
via an isolated TTL-compatible interface. Four GPI inputs and four outputs are
available. See
"GPI Pinouts" on page
128.
Using the REMOTE menu group, you can program the actions of the GPI inputs
and outputs individually. Contact closures on the inputs can trigger a wide variety
of FS-HDR functions. Alarms or loss of video can trigger the GPI outputs.
10/100/1000 LAN
This RJ-45 connector provides an Ethernet 10/100/1000 port for connection
directly to a computer or to a LAN through an Ethernet hub or switch.
SFP In/Out (optional)
All FS-HDR's optional SFP I/O ports support up to 3G SDI operation. In addition, in
Single Channel mode the FS-HDR's SFP ports 5 through 8 In and Out also support
12G and 6GSDI, when equipped with a compatible SFP module.
SDI In/Out
Digital video with embedded audio. Four SDI input and Four SDI Output BNCs.
10 bit 3G SDI is supported. The input and output signals carried on each BNC
connector varies, depending on the link configuration and format selection.
Monitor Output
Two Monitor output connectors are available, BNC (SDI) and HDMI, which output
the same video and audio. In Four Channel Mode you can select which Video
Processor output is sent to both of these Monitor output connectors. Single
Channel Mode always passes the unit's single output to these connectors, and
4K/UltraHD signals are automatically downconverted to 2K/HD.
NOTE: The BNC and HDMI monitor output cannot directly display 4K/UltraHD signals,
and the HDMI output does not include an HDR infoframe.
4K/Ultra HD and HDR signals can be monitored locally using the FS-HDR's extra
outputs (optional SFP modules required) and AJA Hi5-4K Mini-Converters. See
"Local Monitoring with the FS-HDR" on page 39
for more information.
FS-HDR Frame Synchronizer/Converter/HDR-WCG Processor v1.0r1
25
www.aja.com
Advertisement
Table of Contents
