Table of Contents
Advertisement
NOTE: The Dynamic Range Clamp parameter is only active when PQ BT.2020 1000 Nits
No Clamp (default)
100 Nits
3.0 Link Config SDI1, 2, 3, 4
(4Ch only) These parameters determine how 1080p50/60 signal transport is
configured for the Video Processor output BNC connectors. The menu names
and parameters available depend on the currently selected Video Processor. For
example, if Video Processor 1 is selected, the menu title will be 2.0 Link Cfg SDI1
identifying the primary output BNC connector used by that Video Processor. For
Video Processor 2 the menu title will be 2.0 Link Cfg SDI2, etc.
Sngl Link LvlA (default)
Dual Link
Sngl Link LvlB
3. 1 Level B SDI1, 2, 3, 4
(4Ch only) When Single Link Level B has been selected above, the parameters on
the menu below become available for the selected Video Processor.
VID1
VID2
VID3
VID4
Figure 30. Dual Stream 3G MUX Schematic
Video Processor 1
Video Processor 2
See
Figure 14 on page 36
FS-HDR Frame Synchronizer/Converter/HDR-WCG Processor v1.0r1
or Hybrid Log Gamma BT.2100 HDR video is being output.
Vid1 (default)
Vid1 + Vid 2
Vid2 (default)
Vid1 + Vid 2
Vid3 (default)
Vid3 + Vid 4
Vid4 (default)
Vid3 + Vid 4
HD/SD
HD/SD
for more information.
Off (no clamp processing).
Output is cleanly compressed to 100 Nits SDR.
Sets the output transport to 3Gb Level A (single connector).
Sets the output transport to 1.5Gb Dual Link (two connectors,
ST 372).
Sets the output transport to 3Gb Level B-DL (single connector).
When Level B is selected a sub menu becomes available to
choose the Video Processor(s).
Selects only the Vid 1 Processor signal for output.
Select both the Vid1 and Vid2 Processor signals for output (Dual
Stream).
Selects only the Vid 2 Processor signal for output.
Select both the Vid1 and Vid2 Processor signals for output (Dual
Stream).
Selects only the Vid 3 Processor signal for output.
Select both the Vid3 and Vid4 Processor signals for output (Dual
Stream).
Selects only the Vid 4 Processor signal for output.
Select both the Vid3 and Vid4 Processor signals for output (Dual
Stream).
80
www.aja.com
Advertisement
Table of Contents
