Table of Contents
Advertisement
2.0 MADI BNC Delay
Sixty four MADI BNC Level (and related submenus) are available.
3.0 MADIFIB Delay
Sixty four MADI Fiber Level (and related submenus) are available.
NOTE: For level adjustment information, see
MAP Menu Group
IMPORTANT: The settings in this menu group apply to the currently selected audio
The MAP menus provide FS-HDR audio routing controls. Any audio input can be
routed to any audio output, except the Monitor output embedded audio always
matches the monitored video.
About Audio Routing
The following menus control the FS-HDR's audio routing. The general routing
procedure using the front panel is to select the menu of the audio output with
the SELECT knob, and then select the input source you wish to route to that
output with the ADJUST knob. Channel mapping allows different individual audio
channels to be routed to different individual outputs.
See
"System Cabling" on page 33
routing.
1.0 Vid 1 Audio Out
This parameter selects the audio input sources for the selected FS-HDR Video
Processor's audio output channels. The factory default for each output is the
corresponding input: i.e. SDI1 to SDI1, SDI2 to SDI2, etc.
SDI1 - 8
AES/EBU
MADI BNC
MADI Fiber
Mix Down 1 L:R
Mix Down 2 L:R
Sig Gen 1KHz
Sig Gen 400Hz
Mute
Map
When set to SDI1-8, AES/EBU, or MADI:
• The selected source channels are routed to the corresponding output
channels. For example, SDI1 input Ch n to SDI1 output Ch n, where n = 1 thru
16.
FS-HDR Frame Synchronizer/Converter/HDR-WCG Processor v1.0r1
category (EMBED or AES/MADI). These settings are NOT shared with both Four
Channel and Single Channel modes.
The selected source channels are routed to the corresponding output
channels.
The stereo output of the Mix Down 1 Module is routed to the output
channels 1 and 2. The other channels are muted.
(4Ch only) The stereo output of the Mix Down 2Module is routed to
the output channels 1 and 2. The other channels are muted.
The selected tone or mute is routed to every output channel of the
selected Video Processor.
The currently configured mapping is applied to each output channel
of the selected Video Processor. Channel mapping menus for each
output become available.
"1.0 SDI1 Delay" on page 93.
for more information about FS-HDR signal
95
www.aja.com
Advertisement
Table of Contents
