Table of Contents
Advertisement
Caution!
channels. Storing and recalling a P
four channels in that mode. Care must be taken to establish a policy for
the use of FS-HDR Presets, especially if the FS-HDR is operated in Four
Channel mode and the different channels have different users.
During recall, the display reads, Recalling until the recall is finished. On recall
completion, the displays shows the success or failure: Recalled, Failed, or Empty.
A failed or empty recall does not recall anything and leaves the FS-HDR as it was.
(Preset registers are empty until you store something in them.)
During a store, the display reads Storing until the store is finished. On store
completion, the display shows Complete or Failed. A failed store does not store
anything and leaves the preset register as it was. To retry a failed store, turn
SELECT to another preset number and then back to the desired preset number.
1 Factory Preset
This parameter recalls a read-only Factory Preset.
Factory
Recall
1. 1 -1.40 Presets #1-#40
These parameters let you recall, edit the name of, and store an FS-HDR preset
configuration for the selected storage register. Forty storage registers are
available.
Preset #1–#40
[Preset Name]
Recall
Edit Name
Store
Video with Audio Routing
Presets can be used to coordinate audio and video routing. Store and name
presets that match the desired audio inputs to each desired video input, and use
those presets to select the video inputs, causing the configured audio to follow.
Interaction of Presets and GPIs
Triggering presets using GPI inputs offers considerable power but also requires
some care to avoid unexpected results. If you plan to trigger presets using GPIs,
please see the information about the
FS-HDR Frame Synchronizer/Converter/HDR-WCG Processor v1.0r1
In F
our Channel Mode, each Preset saves all the settings for all four
reset will affect all the settings for all
Recalls factory values for all System, Video, Audio, and most Config
parameters. Push ADJUST for four seconds to perform the recall.
The display reports "Factory values" during the recall. User
preferences, network settings, and existing Presets are not
affected by recalling the Factory Preset.
Shows the currently selected preset register number. Turn SELECT
choose the desired register. Then turn ADJUST to choose Recall,
Edit Name, or Store for the selected register.
Shows the name of the selected preset register, which can be
edited.
Recalls that preset. Push ADJUST momentarily to perform (take) the
recall. The display reports "Loading" and "Complete" during the
recall.
Enables editing the name of the preset register. Push ADJUST to
enable editing (blinking character), use the SELECT and ADJUST
knobs to edit the name and then press ADJUST to save the edited
preset register name.
Stores the current set of all System, Video, Audio, and most Config
parameters to the selected preset register.
"Interaction of Presets and GPIs" on page
71
.
59.
www.aja.com
Advertisement
Table of Contents
