Table of Contents
Advertisement
SNMP Configuration Parameters
4.0 SNMP Enable
The SNMP Enable parameter Enables or Disables SNMP messaging between the
FS-HDR and an external client.
Disabled (default)
Enable 1
Enable Both
When Enabled, menus described below are available for configuration.
4. 1 SNMP Trap Destination 1
This parameter determines the SNMP Trap Destination IP address where trap
messages issued by the FS-HDR will be sent.
IP Address
4.2 SNMP Trap Port 1
This parameter determines the SNMP Trap Port 1 used for sending destination
#1 trap messages. UDP Port 162 is the default used for SNMP trap messages.
However, if this port is being used by another protocol or service, you can change
the setting by modifying this parameter.
Variable
NOTE: The SNMP Trap Port number does not blink when changed (as does the Trap
4.3 SNMP Trap Destination 2
This parameter determines the secondary SNMP Trap Destination IP address
where trap messages issued by the FS-HDR will be sent (if desired). This
parameter is similar to
192.168.0.3.
4.4 SNMP Trap Port 2
This parameter determines the SNMP Trap Port used for sending destination #2
trap messages, similar to
FS-HDR Frame Synchronizer/Converter/HDR-WCG Processor v1.0r1
When set to Disabled, the FS-HDR will not issue SNMP trap messages.
When set to Enable 1, the FS-HDR issues SNMP trap messages to Trap
Destination 1 (parameter 4.1) and as defined in the MIB.
When set to Enable Both, the FS-HDR issues SNMP trap messages to
Trap Destination 1 and 2 (parameters 4.1 and 4.3) and as defined in
the MIB.
Set the desired IP address where traps will be sent (usually a client on
your LAN). Default: 192.168.0.3
Select a UDP port for sending FS-HDR trap messages. Default: 162
Destination IP address); if you change the port number and exit the parameter,
the port changes immediately to the new value.
"4.1 SNMP Trap Destination 1"
"4.2 SNMP Trap Port 1"
above. The default is
above. Default is 162.
122
www.aja.com
Advertisement
Table of Contents
