Table of Contents
Advertisement
ADJUST
Turning the ADJUST knob performs these actions:
• Turn ADJUST to change the values of a selected parameter.
• In most cases, leaving a value in place for a moment sets that value.
• To perform special actions, such as recalling a register, push the knob to
confirm the displayed value. Display line 4 indicates such special actions.
• Some parameters having multiple fields, such as IP Address require you to
push the ADJUST knob to select a field, and push again to save changes.
• Hold down the knob to reset a value to the factory default; for multiple field
values, all fields are reset to the default.
• When the STATUS button is selected, pressing ADJUST returns the user to the
last mode and menu selected before SYSTEM -> STATUS was selected.
Button Menus
The general functions accessed by the front panel buttons are listed below:
System Buttons
STATUS
Displays the Status Menu Group, which shows current machine status and error
conditions:
• Video Input and status
• Caption status
• Reference and Genlock status
• Output status
• Power and Temperature status
• System Name display
• Alarms
REMOTE
Displays the Remote Menu Group, which lets you select how to control the
FS-HDR:
• Control by local front panel only, remote sources only, or local and remote
• Authentication
• GPI input and output behavior
VIDEO
Displays the System Video Menu Group, which lets you change or enable system
wide video functions:
• Output frame rate selection
• Genlock reference source selection
• Monitor output settings
• Video input format settings, including 3G setup
CONFIG
Displays the Config Menu Group, which lets you configure the FS-HDR for your
environment:
• System Name setting
• FS-HDR Mode (Single Channel or Four Channel)
FS-HDR Frame Synchronizer/Converter/HDR-WCG Processor v1.0r1
20
www.aja.com
Advertisement
Table of Contents
