Fs-Hdr Processing Examples; Fs-Hdrbout 41 Operating Modes - AJA FS-HDR Installation And Operation Manual

3. Connect a 1080i59.94 HD tri-level sync reference signal to one of the FS-HDR
Ref Loop BNCs, and connect a 75 ohm terminator to the other Ref BNC.
• The REF LED will light blue, indicating the FS-HDR is genlocked to reference.
• The Status menu GEN parameters will report Ref and indicate the format of
• However, because the FS-HDR is still not receiving a compatible video input,
Video Format Status screen
IN1
BKGD
GEN
OUT1
4. Connect a 1080i59.94 SDI video source to the SDI 1 input BNC.
• The front panel will report 1080i59 and an OK status for SDI 1. This indicates
Video Format Status screen
IN1
BKGD
GEN
OUT1
5. Disconnect one of the power cords, leaving the other attached.
• The front panel PWR LED will light red for the power supply with the
• The PS status will report PS1 (or 2) OFF.
6. Reconnect the power cable. The PWR LED for that power supply will light
blue and the power supply status will report OK.
This workflow confirms the FS-HDR powers up successfully and reports reference
and power supply alarms.
NOTE: FS-HDR Reference, Power Supply, and Video Format alarms can be disabled, if

FS-HDR Processing Examples

About FS-HDR Operating Modes
The FS-HDR has two operating modes.
• Single Channel Mode (4K/UHD) has one video processing channel capable
of 4K/UltraHD video, and supports up and down-conversion to and from HD
video.
• 4 Channel Mode (HD/SD) has four video processing channels capable of HD
video, and each channel supports independent up and down-conversion
between HD and SD video.
Both operating modes support various types of High Dynamic Range (HDR) and
Wide Color Gamut (WCG) video, and can perform conversions between them.
The appropriate FS-HDR operating mode should be selected first, because
parameter setting changes only affect the current operating mode.
To change the FS-HDR operating mode:
1. Press the CONFIG System button:
FS-HDR Frame Synchronizer/Converter/HDR-WCG Processor v1.0r1
the incoming reference signal or OK.
No Input, will be reported for IN1.
SDI 1
Black
Ref
no alarm condition exists.
SDI 1
Black
Ref
removed cord.
desired. This will prevent the LEDs from going red, but will not affect SNMP or
front panel status displays.
Video Format Alarm Status screen
No Input IN1 SDI 1
1080i59 BKGD Black
1080i59 GEN Ref
1080i59 Rate
Video Format Alarm Status screen
1080i59 IN1 SDI 1
1080i59 BKGD Black
1080i59 GEN Ref
1080i59 OUT1
41
OK
OK
OK
59/29/23
OK
OK
OK
1080i59
www.aja.com