Table of Contents
Advertisement
Mac Ping Procedure
1. Find the Utilities Folder inside of the Applications Folder.
2. Locate the "Terminal" utility application and double-click it.
3. On the FS-HDR, select the STATUS button and go to System Status menu
(with the FS-HDR name) to read the unit's currently configured IP address.
NOTE: The STATUS menu always shows the FS-HDR's current IP address. The IP address
4. At the Mac terminal prompt, enter ping and the IP address noted in
above. For example: ping 192.168.0.2 (and press Return).
5. If successful, the ping utility will respond that packets were sent, received
and how long it took. For example:
64 bytes from 192.168.0.2: icmp_seq=0 ttl=64 time=0.590 ms
6. If unsuccessful, check the FS-HDR network settings and resolve the problem
with your IT administrator.
Windows PC Ping Procedure
1. From the Start button, select the All Programs menu.
2. Select Accessories/Command Prompt from the All Programs list.
3. On the FS-HDR, select the STATUS button and go to System Status menu
(with the FS-HDR name) to read the unit's currently configured IP address.
NOTE: The STATUS menu always shows the FS-HDR's current IP address. The IP address
4. In the PC Command Prompt utility, enter ping and the IP address noted in
step 3. For example: ping 192.168.0.2 (and press Return)
5. If successful, the ping utility will respond that packets were sent, received
and how long it took. For example:
64 bytes from 192.168.0.2: icmp_seq=0 ttl=64 time=0.590 ms
6. If unsuccessful, check the FS-HDR network settings and resolve the problem
with your IT administrator.
Web Browser Control
To control the FS-HDR from a web browser on a network attached computer,
enter the FS-HDR IP address as a URL in the browser. For example, if the
FS-HDR IP address were "90.0.6.31", you would then type into the web browser:
http://90.0.6.31. This topic is explained in greater detail in Chapter 5: Browser
Remote Control.
NOTE: The web UI (browser GUI) will keep up with most changes initiated at the front
FS-HDR Frame Synchronizer/Converter/HDR-WCG Processor v1.0r1
on the CONFIG menu is a database entry, which occasionally may not be the
address the unit is using.
on the CONFIG menu is a database entry, which occasionally may not be the
address the unit is using.
panel. However, the web UI may not reconnect (displays "Disconnected") when
network changes are initiated at the FS-HDR front panel. To manually reconnect,
type the new IP address into the browser, or click the browser Refresh button.
Sometimes the browser caches the old FS-HDR address. If you can't get the
browser to connect, try clearing the Browser history to clear the cache, and then
enter the new address again.
Step 3
31
www.aja.com
Advertisement
Table of Contents
