Table of Contents
Advertisement
See
"Networking" on page 29
FS-HDR to a network. Consult your network administrator about how to configure
network settings.
IP Address Type
IP Address Type determines the type of TCP/IP network configuration used by the
FS-HDR. DHCP enables the FS-HDR to connect to the network DHCP server, which
assigns the IP Address, Netmask, and Gateway automatically. Static lets you set
these parameters manually.
NOTE: If the IP Address Type is DHCP, the IP Address, Netmask, and Default Gateway
DHCP (default)
Static Addr
IP Address
IP Address determines the static IP address used by the FS-HDR for TCP/IP
networking. (Networking is discussed in Chapter 3, Network Connection.) Consult
your network administrator about how to set this value.
Variable
Netmask
Netmask determines the subnet mask used by the FS-HDR for TCP/IP networking.
Variable
Default Gateway
Default Gateway determines the gateway or router used on your LAN for TCP/IP
networking.
FS-HDR Frame Synchronizer/Converter/HDR-WCG Processor v1.0r1
for detailed setup instructions for connecting the
are gray, indicating they are set automatically and cannot be changed unless
IP Address Type is first set to Static. Changes are saved and activated upon
confirmation using the Apply button.
Select automatic IP address assignment from the LAN DHCP server.
If the FS-HDR cannot find a DHCP server, it fails over to the static IP
address.
Assign a static IP address manually. The factory default static IP
address: 192.168.0.2
If IP Address Type is set to DHCP, the IP address is set automatically by
the network DHCP server and cannot be entered here.
If IP Address Type is set to Static, enter an IP address compatible with
your LAN here. Also enter a netmask and default gateway address
in the following two parameters. Click Apply when you are ready to
apply all three entries to change the FS-HDR's network addressing.
If IP Address Type is set to DHCP and there is a DHCP failure, the IP
address is set to the static IP address. The default static IP address is
192.168.0.2
Enter a subnet mask compatible with your LAN. This is only needed
for Static IP configurations. The factory default Subnet Mask is
255.255.255.0
If IP Address Type is set to DHCP, the Subnet Mask is set by the DHCP
server and cannot be changed by the user.
101
www.aja.com
Advertisement
Table of Contents
