Display Intensity; Fan Speed; Serial Number; Software Version - AJA FS-HDR Installation And Operation Manual

Frame synchronizer/converter/hdr-wcg processor
Hide thumbs Also See for FS-HDR:
Table of Contents

Advertisement

10 Display Intensity

This parameter determines the brightness of the alphanumeric display and front
panel LEDs.
Variable

11 Fan Speed

This parameter determines the speed (and sound level) of the FS-HDR's internal
cooling fans. For long term reliability, the fan speed should be set as high as
possible, only lowering the speed if fan noise is a concern. At 25C (77F) ambient
temperature any speed setting (1 to 10) provides adequate cooling. At 40C (104F)
ambient, a fan speed of 5 or higher is recommended. The FS-HDR also has built-in
thermal protection that will increase the fan speed automatically if necessary.
Variable

12 Serial Number

This parameter displays the FS-HDR's unique serial number. Please reference this
number if you contact AJA customer support.

13 Software Version

This parameter displays the FS-HDR's software version number.

14 Reboot

This parameter lets you reboot the FS-HDR. Press and hold in both front panel
knobs simultaneously to reboot.
During reboot, the display shows [Rebooting], goes dark momentarily, and then
shows the percentage of progress as the system reboots. Reboot should take no
longer than 90 seconds.

AUDIO Menu Group

The following descriptions explain the AUDIO Menu Group, which allows you to
make adjustments to the FS-HDR's sample rate converters, Mix Down Modes, and
some other system wide settings.

1 MADI Output Mode

This parameter controls the number of MADI channels sent to both the MADI BNC
and Fiber output connectors, 64 or 56.
If the FS-HDR receives 56 channels and is set to output 64 channels, active
silent channels 57 to 64 are added to the output. When the FS-HDR receives 64
channels and is set to output 56 channels, channels 57 to 64 are dropped on the
output.
64ch (default)
56ch
FS-HDR Frame Synchronizer/Converter/HDR-WCG Processor v1.0r1
Dim or brighten the alphanumeric display and activity indicator
LEDs in steps from 1 (dim) to 8 (brightest).
Changes the fan speed in steps from 1 (slow) to 10 (fast).
Default is 10.
Sixty four audio channels selected for MADI output.
Fifty six audio channels selected for MADI output. MADI output
channels 57-64 will not be available.
66
Default: 6
www.aja.com

Advertisement

Table of Contents
loading

Table of Contents