Table of Contents
Advertisement
If the FS-HDR cannot get an IP address from the network DHCP server, the FS-HDR
will automatically use a preset factory static IP address of 192.168.0.2. You can
access the FS-HDR using the default static address as follows:
1. Set your computer's IP address to whatever address you prefer in the
192.168.0 (class C) network.
2. Set the computer's Subnet mask to 255.255.255.0 (most PCs default to the
proper netmask when the address is set).
3. Set the gateway address, if used, to match the FS-HDR default: 192.168.0.1.
Alternatively, change the FS-HDR gateway address to match your gateway:
A. Press CONFIG, turn SELECT to 3.4 Default Gateway, push and then turn
B. Turn SELECT to advance to the next set of numbers, and turn ADJUST to set
C. Continue using SELECT and ADJUST to set the full address.
D. When finished, push ADJUST momentarily to save the address.
5. Run a browser on the computer and type "192.168.0.2" (the factory static IP
address). You should now see the FS-HDR's browser status screen.
When you can access the FS-HDR screens, see
97
for details about configuring the FS-HDR using a browser.
Networking the FS-HDR Using Your Own Static IP
If you don't want to use DHCP or the default static IP address, you can set your
own static IP address:
1. Select the CONFIG button and use the SELECT knob to navigate to
parameter 2.1 IP CONFIG. Use the ADJUST knob to select Static.
2. Turn SELECT to navigate to parameter 3.2 IP ADDRESS. The display shows
the default static IP address: 192.168.0.2.
3. Change the IP address as follows.
A. Push the ADJUST knob momentarily so that the first octet (set of numbers)
B. Turn SELECT to advance to the next set of numbers, and turn ADJUST to set
C. Continue using SELECT and ADJUST to set the full address.
D. When finished, push ADJUST momentarily to save the address.
5. Turn SELECT to advance to 3.3 Subnet Mask. Use the SELECT and ADJUST
knobs as in the previous step to set the desired subnet mask.
6. Turn SELECT to advance to 3.4 Default Gateway. Use the SELECT and ADJUST
knobs as in the previous step to set the desired gateway address.
7. Run a browser on the computer and type in the IP address you set for the
FS-HDR. You should now see the FS-HDR's Status screen.
When you can access the FS-HDR screens, see
97
for details about configuring the FS-HDR using a browser.
Using Ping to Test the Network Connection
If you have connected the FS-HDR to a computer and set up the IP address and
still do not see the FS-HDR screens in your browser, you can ping the network to
verify the connection. Simply run the Ping utility from a Mac OS X or Windows
PC computer attached directly or on the same LAN as the FS-HDR as described
below:
FS-HDR Frame Synchronizer/Converter/HDR-WCG Processor v1.0r1
ADJUST to change the first group of digits.
these numbers.
blinks, and then turn ADJUST to change the numbers.
these numbers.
"Browser Remote Control" on page
"Browser Remote Control" on page
30
www.aja.com
Advertisement
Table of Contents
