Table of Contents
Advertisement
Video Select Buttons VID1-VID4
As described in
VID4 front panel buttons select a Video Processor channel. When selected, the
nine Video buttons on the right are used to select a category of menus.
Table 7. Video Menu Group Buttons activated with Channel Select buttons.
INPUT
ANC
COLOR
Single Channel Mode has one Video Processor, to which all the parameter
settings in these menu groups apply. Four Channel Mode has four Video
Processors. Changes to Video Select Button parameter settings only apply to the
currently selected Video Processor, whose VID1-4 button will be illuminated.
INPUT Menu Group
IMPORTANT: In Four Channel Mode, the settings in this menu group apply only to the
1 Input
These parameters perform input video source selection for the Video Processor.
SDI1 (4Ch default)
SDI2-8
1/2, 3/4, 5/6, 7/8 DualLink
1-4 Quad Link (Single Ch
default)
5-8 Quad Link
Source Memory
Changing the Video Input selection automatically selects new values for Proc
Amp parameters and Color Corrector (RGB) parameters. Each video source
remembers its own Proc Amp and Color Corrector settings. This is referred to as
Source Memory.
Dual Link
Dual Link referred to here is 1080p50/59.94/60 on two 1.5 Gb HD-SDI connections,
or 4K/UltraHD low frame rate video on two 3 Gb connections. Selecting Dual Link
as the Video Input will allocate both SDI Inputs for Dual Link use. The SFP inputs
operate the same way.
Quad Link
Quad Link referred to here is 4K/UltraHD on four 1.5 Gb HD-SDI connections,
or 4K/UltraHD high frame rate video on four 3 Gb connections. Selecting Quad
Link as the Video Input will allocate all four SDI Inputs for Quad Link use. The SFP
inputs operate the same way.
See
"System Cabling" on page 33
routing.
FS-HDR Frame Synchronizer/Converter/HDR-WCG Processor v1.0r1
"Operational Summary" on page 18
FORMAT
TIMING
SCALE
TSTGEN
KEYER
FREEZE
selected Video Processor (VID1- VID 4).
the VID1, VID2, VID3 and
Select SDI1 as the input source.
Selects either SDI2 through SDI8 as the input source.
Selects SDI 1/2, or SDI 3/4, or SDI 5/6 or SDI 7/8 DualLink as the
input source, linking both SDI inputs.
(Single Ch only) Select SDI 1-4 SDI QuadLink as the input source,
linking all four of the inputs
(Single Ch only) Select SDI 5-8 SDI QuadLink as the input source,
linking all four of the inputs.
for more information about FS-HDR signal
72
www.aja.com
Advertisement
Table of Contents
