Table of Contents
Advertisement
Chapter 4 – Display Menus
Overview
The FS-HDR is generally controlled using two different methods: (1) direct control
using the front panel buttons, knobs, and display menus, (2) remote control using
a web browser. This chapter describes the first, using the front panel controls,
which is the most direct way to configure and use an FS-HDR. The other method,
using a computer, is described in the next chapter. A third method of FS-HDR
control, using external GPI contacts, is described in various locations in this
manual.
FS-HDR Modes, System Parameters, and Video Parameters
The FS-HDR also operates in two distinct modes, either Four Channel Mode or
Single Channel Mode. Menu parameters settings made in one mode may or may
not affect the operation of FS-HDR when it is set to the other mode. For example,
in Single Channel Mode, setting Output Image Mapping to 2SI will not affect
operations in Four Channel Mode, because that parameter only affects 4K or
UltraHD formats that are not available in Four Channel mode. However, changing
the IP Address Type (DHCP, Static) will affect FS-HDR operation in both modes
regardless of the mode in which that parameter was adjusted.
In general, settings made for FS-HDR system operation, like IP address, Output
Frame Rate, Genlock, etc. affect operation in both Four Channel and Single
Channel mode. These front panel menu settings are accessed via the three
System buttons (VIDEO, CONFIG, and AUDIO).
The Channel Select AES menus (and associated LEVEL and DELAY menu
parameters for AES and MADI), also affect the FS-HDR in both operating modes.
Separate MAP parameters for audio routing, however, are saved for each Video
Processor, so changing mapping in one operating mode will not affect mapping
in the other mode.
The Channel Select EMBED menus provide LEVEL, DELAY, and MAP menu
parameters for embedded SDI audio. Because both operating modes use the
same SDI inputs, adjustment to these parameters affects both modes.
Video parameter settings in the Channel Select VID1-4 menus (and associated
VIDEO submenus) apply to only the current FS-HDR operating mode. In Four
Channel Mode, each VID channel accesses separate settings for only that channel,
allowing four different conversions to take place simultaneously. In Single
Channel Mode, only one set of video parameters exists that apply to that single
channel. Changing video parameters in Four Channel Mode will not affect any
video settings stored in Single Channel Mode.
NOTE: One exception is in the REMOTE Menu Group. The Remote Control setting (Local,
FS-HDR Frame Synchronizer/Converter/HDR-WCG Processor v1.0r1
Remote) affects both Four Channel and Single Channel mode, but separate sets
of GPI In and GPI Out settings exist for each operating mode. Single Channel
Mode has only one set. Separate GPI inputs and outputs are needed for the
different functionality available in these two modes.
53
www.aja.com
Advertisement
Table of Contents
