Opengear And Aja; Og-3G-Ama I/O Connections; User Controls - AJA OG-3G-AMA Installation And Operation Manual

• 8 Channel Balanced Analog Audio I/O
• 8x 3-Pin Terminal Block Audio Connectors
• 8x Audio Mating Connectors
• Remote Configuration through DashBoard Control System for an openGear
Frame
• Local Configuration through DIP Switches
• Embed To Selection (Ch 1-8 or Ch 9-16) on a Channel Pair Basis
• Disembed From Selection (Ch 1-8 or Ch 9-16) on a Channel Pair Basis
• Strip or Pass Incoming HANC Data
• Set Analog Audio Operating Level
• Requires Two Slots in openGear Frame
• Rear I/O Card Included

openGear and AJA

openGear is an open-architecture, modular frame system designed by Ross
Video and supported by a diverse range of terminal equipment manufacturers,
including AJA. Ross Video manufactures the frames, power supplies and network
cards for openGear. AJA is a reseller of the openGear frames.
AJA Video is a leading manufacturer of video interface technologies, converters,
digital video recording solutions and professional cameras, bringing high-
quality, cost-effective products to the professional, broadcast and post-
production markets. AJA products, including openGear cards, are designed and
manufactured at our facilities in Grass Valley, California.

OG-3G-AMA I/O Connections

Figure 1. I/O Connections for the OG-3G-AMA
SDI Input
BNC (J1)
AUD1
AUD 2
AUD 3
AUD 4
Each 3-pin analog audio connector carries one channel of analog audio that can
be configured to be an input or an output.

User Controls

User Control options for the OG-3G-AMA consist of DIP switches on the card
and the DashBoard Control System from Ross Video. Both options are described
below.
OG-3G-AMA openGear Card v1.0
SDI Output
BNC (J2)
AUD 5
AUD 6
AUD 7
AUD 8
5 www.aja.com