Link Config Sdi1-4; Link Config Sdi5-8; Output Image Mapping; Sd Aspect Ratio - AJA FS-HDR Installation And Operation Manual

Frame synchronizer/converter/hdr-wcg processor
Hide thumbs Also See for FS-HDR:
Table of Contents

Advertisement

3.0 Link Config SDI1-4

(Single Ch only) These parameters determine how 1080p50/60 signal transport is
configured for the Video Processor output BNC connectors.
QuadLnk Lvl A (default)
QuadLnk LvlB
Sngl Lnk LvlA
Dual Link
Sngl Lnk LvlB
See
"Single Channel Mode Output Examples" on page 38

4.0 Link Config SDI5-8

(Single CH only) These parameters determine how 1080p50/60, 6Gb, and 12Gb
signals are formatted for the Video Processor SFP output ports.
QuadLnk Lvl A (default)
QuadLnk Lvl B
Sngl Lnk LvlA
Dual Link
Sngl Lnk LvlB
NOTE: 6Gb and 12Gb signal output requires compatible SFP modules.
See
"Single Channel Mode Output Examples" on page 38

5 Output Image Mapping

(Single Ch only) This parameter sets the structure of the UHD or 4K output video.
The image can be divided into four quadrants (Square Division [SQD] format, see
SMPTE 425-3, Appendix B), or interleave (2 Sample Interleave [2SI] format (see
SMPTE 425-5, Section 8).
Quadrant (default)
Interleave

6 SD Aspect Ratio

This parameter selects the type of SD-to-SD Aspect Ratio Conversion (ARC)
performed on an incoming selected SD source input. This parameter has an effect
only when the input and output are both SD (525i or 625i).
Off (default)
Letterbox
H Crop
Pillarbox
V Crop
14x9
FS-HDR Frame Synchronizer/Converter/HDR-WCG Processor v1.0r1
Sets the output transport to Quad Link Level A (four
connectors).
Sets the output transport to Quad Link Level B-DL (four
connectors).
Sets the output transport to 3Gb Level A (single connector).
Sets the output transport to 1.5Gb Dual Link (two connectors)
Sets the output transport to 3Gb Level B-DL (single connector).
.
Sets the output transport to Quad Link Level A (four connectors).
Sets the output transport to Quad Link Level B-DL (four
connectors).
Sets the output transport to 3Gb, 6Gb, or 12Gb Level A (single
connector).
Sets the output transport to 1.5Gb or 3Gb Dual Link (two
connectors)
Sets the output transport to 3Gb Level B-DL (single connector).
.
The output is Quadrant format (Square Division).
The output is Two Sample Interleave format. The front panel 2SI LED
will light when selected.
No ARC conversion will be performed.
Selects the indicated ARC conversion.
81
www.aja.com

Advertisement

Table of Contents
loading

Table of Contents