Table of Contents
Advertisement
Controlling Multiple FS-HDRs
From any screen, you can see at-a-glance all of the AJA devices present on the
same local LAN as well as the current FS-HDR you are controlling. Clicking on any
of the listed systems will bring up the Status screen of that device.
NOTE: The FS-HDR you control may be running a different software version, so screens
Resetting Values To Factory Default Settings
FS-HDR web browser screens feature many user controls that can be reset to
factory default values by simply "right-clicking" on the parameter label. When you
right-click, the browser displays a Reset to Factory popup that if clicked will cause
the parameter to be reset.
NOTE: This reset procedure only works with computers that allow right-clicking. Some
You can perform a global reset to factory values of all System, Video, Audio, and
most Config parameters (the same set of parameters acted on by a Preset Recall).
Caution! Recall Factory Preset changes the settings for both Single Channel and
Four Channel FS-HDR operating modes to their factory default values. .
To perform a global reset:
1. Go to the Presets screen.
2. Click on the Recall button in the Factory Preset row.
User preferences, network settings, and existing Presets are not affected by
recalling the Factory Preset.
Drop Down Parameter Operation
Most parameters available on the browser are selected from a drop-down list.
The currently active parameter is displayed. Click on the down arrow symbol next
to the parameter to display the list and select an alternative value. The FS-HDR
will immediately operate with the new setting.
Slider Operation
Some screens contain slider controls for setting values. To set a value, you can
click on a slider to select it and then use the mouse to drag the slider to the
position you desire. For fine tuning, while the slider is selected (highlighted by
a blue border), use the keyboard left and right arrow keys to change the value
one unit at a time. Or you can enter the value directly by clicking on the number
displayed above the slider, type in your number then hit Enter to have it take
effect. After setting a slider's position, click on the page's background area (blue
highlight turns off) to ensure the change is confirmed and saved.
FS-HDR Frame Synchronizer/Converter/HDR-WCG Processor v1.0r1
may look different. It's a good idea to have all your devices running the most
current software and the same version. Also, if the Default Gateway is not
configured properly, other AJA devices will not be visible. If the display shows no
devices found, check the gateway setting.
computers may not permit this operation.
99
www.aja.com
Advertisement
Table of Contents
