General Fs-Hdr Setup - AJA FS-HDR Installation And Operation Manual

Frame synchronizer/converter/hdr-wcg processor
Hide thumbs Also See for FS-HDR:
Table of Contents

Advertisement

2. Select 2 FS-HDR Mode
3. Select either 4K/UHD or HD/SD and press ADJUST.
NOTE: The FS-HDR must restart after its operating mode has been changed.

General FS-HDR Setup

For any FS-HDR operation the following general menu items will need to be set
correctly for your workflow. Some default FS-HDR settings may be applicable.
The following items assume front panel control. Web browser control may require
additional network configuration steps.
Select Single or Four Channel Mode (Reboot Required)
Config Menu: 2 FS-HDR Mode
• HD/SD (Four Channel mode), or 4K/UHD (Single Channel mode)
NOTE: See
Select Frame Rate
Video Menu: 1 Output Frame Rate
• 59/29/23 (default), or 50/25, or 60/30/24
Select Genlock
Video Menu: 2 Genlock
• Reference (default), or Freerun, or SDI (n)
Configure Video Input
VID (n), INPUT Menu, 1 Input
• SDI (n) (default), or (n/n) Dual Link, or Quad Link
Configure Video Output
Vid (n), FORMAT Menu, 1 Output Format
• Follow Input (default), or Follow Ref, or (raster/framerate)
• Various conversion settings in related menus may also apply.
Dynamic Range Clamp (HDR Output Only)
Vid (n), FORMAT Menu, 2.2 Dynamic Range Clamp
The Dynamic Range Clamp parameter can be used to quickly preview what an
HDR signal may look like on an SDR monitor, without having to switch between
HDR and SDR modes on that monitor (which may go black during the change-
over). The FS-HDR default setting is No Clamp, and this generally should be used
during production. When set to 100 Nits, the HDR signal is cleanly compressed to
SDR, allowing quick A/B comparison on an HDR display in HDR mode.
NOTE: The Dynamic Range Clamp parameter is only active when PQ BT.2020 1000 Nits
Additional Settings
Other more specialized settings not discussed in the Quick Start Guide may also
apply to your workflow. Refer to the FS-HDR Installation and Operation Guide
available on the AJA website for more information.
FS-HDR Frame Synchronizer/Converter/HDR-WCG Processor v1.0r1
Step 1 on page 29
for procedure.
or Hybrid Log Gamma BT.2100 HDR video is being output.
42
www.aja.com

Advertisement

Table of Contents
loading

Table of Contents