4. To view a report, click the link for that report.
5. To email this report, follow the instructions in
Diagnostic Commands
The following CLI commands correspond to the web page entries described above.
To display the Address Resolution Protocol table (for IPv4) or the Neighbor table (for IPv6)
for mapping IP Addresses to hardware addresses:
diag arp|arp6 [email <Email Address>]
Note:
You can optionally email the displayed information.
To display a report of network connections:
diag netstat [protocol <all|tcp|udp>] [email <Email Address>]
Note:
You can optionally email the displayed information.
SLC™ 8000 Advanced Console Manager User Guide
Figure 13-8 Maintenance > Diagnostics
Emailing Logs and Reports (on page
13: Maintenance
293).
288
Need help?
Do you have a question about the SLC 8000 and is the answer not in the manual?