Device Port Commands; Figure 8-9 Sensorsoft Status - Lantronix SLC 8000 User Manual

8: Device Ports
4. Click the Apply button.
5. To view the status detected by the Sensorsoft, click the Show Status link in the far right
column of the table.

Figure 8-9 Sensorsoft Status

Device Port Commands

The following CLI commands correspond to the web page entries described above.
To configure a single port or a group of ports (for example, set deviceport port 2-5,6,12,15-
16 baud 2400):
set deviceport port <Device Port List or Name> <one or more device port
parameters>
Parameters
assertdtr <enable|disable>
auth <pap|chap>
banner <Banner Text>
baud <300-230400>
breakseq <1-10 Chars>
calleridcmd <Modem Command String>
calleridlogging <enable|disable>
cbcpnocallback <enable|disable>
cbcptype <admin|user>
chapauth <chaphost|localusers>
chaphost <CHAP Host or User Name>
checkdsr <enable|disable>
closedsr <enable|disable>
connectedmsg <enable|disable>
databits <7|8>
device <none|sensorsoft|rpm> dialbackeretries <1-10>
dialbackdelay <PPP Dial-back Delay>
dialinlist <Host List for Dial-in>
dialoutnumber <Phone Number>
dialoutlogin <User Login>
dialbacknumber <usernumber|Phone Number>
dodauth <pap|chap>
dodchaphost <CHAP Host or User Name>
SLC™ 8000 Advanced Console Manager User Guide 138