Lantronix SLC 8000 User Manual page 290

diag nettrace <one or more parameters>
Parameters
ethport <1|2>
host <IP Address or Name>
numpackets <Number of Packets>
protocol <tcp|udp|icmp|esp>
verbose <enable|low|medium|high|disable>
To display CPU usage, memory usage and tasks.
diag top [parameters]
Parameters
continuous <enable|disable>
count <Number of Iterations to Display>
delay <Delay in Seconds>
numlines <Number of Lines to Display>
Defaults: count=1, delay = 5 seconds
To display information on the internal memory, storage and processes of the SLC 8000
advanced console manager:
diag internals
Enable debug printing on the next SLC reboot:
diag internals [printapplication <enable|disable>
printconnection <enable|disable>
printmanagement <enable|disable>
Note: This command is available on the web interface as SLC Internals under
Maintenance > Diagnostics.
To display information about USB buses and the devices connected to them, including the
mapping between a USB device and the SLC port:
diag usb [<parameters>]
Parameters
treedisplay <enable|disable>
mapdevice <enable|disable>
email <Email Address>
Defaults: treedisplay=enable
Note: For "mapdevice enable", the port numbers will display at the end of the line in
square brackets.
SLC™ 8000 Advanced Console Manager User Guide
13: Maintenance
290