Lantronix SLC 8000 User Manual page 279

To configure how long the SLC waits for boot completion before forcing a reboot:
admin firmware watchdog <disable|180-1800 seconds>
Sets the boot bank to be used at the next SLC reboot (for dual-boot SLCs):
admin firmware bootbank <1|2>
Note: It is recommended that you wait at least two weeks before copying a newly
upgraded bank to the original boot bank. This allows you to roll back the upgrade in the
unlikely event that there is an issue.
To set the FTP/TFTP/SFTP server used for firmware updates and configuration save/
restore:
admin ftp server <IP Address or Hostname> [login <User Login>] [path
<Directory>]
To view FTP settings:
admin ftp show
To set the FTP server password and prevent it from being echoed:
admin ftp password
To restore the SLC unit to factory default settings:
admin config factorydefaults [savesshkeys <enable|disable>] [savesslcert
<enable|disable>][savescripts<enable|disable>][preserveconfig <Config
Params to Preserve>]
<Config Params to Preserve> is a comma-separated list of current configuration
parameters to retain after the config restore or factorydefaults:
nt – Networking
sv – Services
dt – Date/Time
ra - Remote Authentication
To restore a saved configuration to the SLC 8000 advanced console manager:
admin config restore <Config Name> location
<local|ftp|sftp|nfs|cifs|usb|sdcard> [nfsdir <NFS Mounted Dir>]
[usbport <U1|U2>] [savescripts<enable|disable>] [savesshkeys
<enable|disable>] [savesslcert <enable|disable>]
[preserveconfig <Config Params to Prserve>]
<Config Params to Preserve> is a comma-separated list of current configuration
parameters to retain after the config restore or factory defaults:
nt – Networking
sv – Services
dt – Date/Time
ra - Remote Authentication
SLC™ 8000 Advanced Console Manager User Guide
lu – Local Users
dp –Device Ports
ub –USB Port/SD Card
lu – Local Users
dp – Device Ports
ub – USB Port/SD Card
13: Maintenance
279