How To Customize Operation - Furuno FAR-2218-BB Operator's Manual

1. OPERATIONAL OVERVIEW
1.10

How to Customize Operation

Several operation items can be customized to suit
your needs.
1. Open the menu.
2. Select [9 INITIAL SETTING].
3. Select [5 OPERATION]. The [OPERATION]
menu appears.
4. Referring to the table below, press the menu item
number to select the appropriate menu item to
customize. For the purpose of the this example,
press the 3 MODE key to set up the key beeps.
Menu items
[2 MOUSE WHEEL
DIR]
[3 KEY BEEP]
[4 OWN SHIP VEC-
TOR]
[5 STERN UP RM]
[6 SHUTTLE FERRY] Sets the shuttle ferry mode to use.
[7 ICING PREVEN-
TION]
[8 HDG FINE AD-
JUST]
5. Select the required setting by pressing the menu item number. For this example,
set [3 KEY BEEP] to [HIGH]. Press the 3 MODE key to highlight [HIGH].
For [8 HDG FINE ADJUST] and other menu items with a setting range, spin the
scrollwheel, or use the number keys to adjust the required setting.
Note: Regarding input for [8 HDG FINE ADJUST], when using the number keys,
the indication is first selected as a whole. At this time, you can toggle between plus
"+" or minus "-". Press the 8 key for "-", press the 2 key for "+". If single digits are
highlighted, toggle is not possible. In this case, press the CANCEL TRAILS key
to re-highlight the whole indication.
1-16
Sets the direction of the wheel drive (scrollwheel).
• [NORMAL]: Scroll downwards to increase, or upwards to de-
crease the value.
• [REVERSE]: Scroll directions are reverse of [NORMAL].
Changes the key beep volume.
Select [OFF] to silence the key beeps. Select [LOW], [MID],
[HIGH] to adjust the volume for key beeps.
Select how the own ship vector is displayed.
• [OFF]; Own ship vector is not displayed.
• [HDG]: Vector is displayed in heading direction.
• [COURSE]: Vector is displayed in course direction.
Select [ON] to show HEAD UP RM display in reversed.
Note: This item is shown for A/B-types only.
• [OFF]: Shuttle ferry mode is deactivated.
• [MODE1]: Shuttle ferry mode is activated. See "Shuttle ferry
mode" on next page.
• [MODE2]: Shuttle ferry mode is activated. See "Shuttle ferry
mode" on next page.
Note: Shuttle ferry mode requires an external switch.
Select [ON] to rotate the antenna without transmission, to pre-
vent ice buildup. See section 1.52.
Adjusts the heading line location. 0.0°, the default setting,
shows the heading line pointing towards the top of the screen.
Description