How To Display Routes - Furuno FAR-2218-BB Operator's Manual

3. Select [8 NAV LINE SET]. The [NAV LINE SET] menu appears.
4. Select [2 SELECT NAV LINE].
5. Spin the scrollwheel, or input the number from the
keyboard, to assign a number to the route. The in-
put areas for [3 NAV LINE], [4 NAV LINE ENTRY]
and [5 CLEAR DATA] become active.
6. Select [3 NAV LINE NAME].
7. Referring to section 1.5.2, assign a name to the
route. You can use up to 15 characters in the
name.
8. Select [4 NAV LINE ENTRY].
9. Spin the scrollwheel to select a waypoint, then left-
click.
10. Repeat step 9 until all waypoints for the route are
entered.
When the last waypoint is entered, move the cur-
sor to the next blank input area, then left-click, or
assign the last waypoint as "000" using the numer-
ic keys. If 30 waypoints are entered, the setting process for waypoints is automat-
ically completed.
11. Close the menu.
5.6.2

How to display routes

To display internal routes or received routes, follow the procedure below.
1. Open the menu.
2. Select [8 NAV LINE•WPT]. The [8 NAV
LINE•WPT] menu appears.
3. Select [2 NAV LINE DATA SOURCE].
4. Select the desired source, referring to the list be-
low.
• [OFF]: No routes are displayed.
• [EXT DATA]: Routes received from external
sources are displayed.
• [INTERNAL DATA]: Routes saved in the inter-
nal memory are displayed.
For [INTERNAL DATA], see step 5; for [EXT DA-
TA], see step 8.
5. Select [NAV LINE SELECT].
6. Spin the scrollwheel to select the desired route number, then left-click.
7. Select the direction you want to navigate the route in.
[FORWARD]: Navigate the route in the direction in which it was created.
[REVERSE]: Navigate the route in reverse of the direction in which it was created.
8. Close the menu.
5. VIDEO PLOTTER OPERATION
5-17