Anchor Watch - Furuno FAR-2218-BB Operator's Manual

1. OPERATIONAL OVERVIEW
Category
CPA, TCPA
BCR, BCT
Own ship data
Note: When the antenna is located some distance from the CCRP, the CCRP can be
outside the bearing cursor in true-motion or off-center. Also, when the CCRP is set as
a reference point, some parts of the bearing cursor are not displayed.
1.50

Anchor Watch

The anchor watch feature alerts you when your ship has traveled a distance greater
than a threshold value, when it should be at rest. When the anchor watch is active, an
orange dashed circle marks the anchor watch range.
If your ship drifts more than the anchor watch setting, the alert "ANCHOR WATCH"
appears in the [ALERT] box. The alert is escalated from warning level to alarm level if
the alert is not acknowledged within one minute. Also, if your vessel returns to within
the tolerable radius, the alert status is automatically changed to rectified.
Anchor watch
alarm setting
Alarm is
triggered
1. Open the menu.
2. Select [4 ALERTS].
3. Select [4 ANCHOR WATCH].
4. Select [ON] to enable [ANCHOR WATCH], then press the ENTER MARK key.
5. Spin the scrollwheel to set the distance for the alert. Press the ENTER MARK key
to apply the setting.
6. Close the menu.
1-90
Item
Table continued from previous page
Calculated with an-
tenna position at
center.
Calculated from bow position.
Heading Data is taken from respective sensors, re-
gardless of reference point selected.
Speed
Course over ground
Speed over ground
Own L/L Location of the CCRP.
Own ship location when
anchor watch is set
Own ship moves
outside watch zone
Reference point
ANT CCRP
Calculated with
CCRP at center.